Who we work for
Municipal directional drilling
Cities, counties and utility districts bore because a street that stays open is cheaper than one that is cut, backfilled and repaved. Here is where HDD fits in municipal work.
Water-main renewal under live streets
The most common municipal bore is a new water main installed beside or below the old one while the old one stays in service. Services are transferred one at a time, the new main is tested and disinfected, and the old main is abandoned. The pavement is cut only at tie-ins and services. Programs that once closed a street for a block a week now finish a block in days with traffic moving.
Sewer
Force mains from lift stations and pressure-sewer systems are bored like water mains. Gravity sewer crossings under highways and railroads are installed by auger boring in a steel casing on exact grade. Sewer-separation and storm-drain crossings use the same methods.
Fiber, signals and lighting
City fiber networks, traffic-signal interconnect and street-lighting conduit run along every arterial and cross every intersection. Boring the conduit between handholes keeps the intersections open and the pavement intact, and leaves spare duct for the next system.
Procurement and specifications
Most municipalities specify HDD by reference to ASTM F1962 for pipe pullback design and their own standards for cover, pipe material, tracer wire, testing and restoration. Bids are per foot by diameter with crossings, pits and traffic control as separate items. A pre-bid meeting on the ground, with the utility records on the table, is the best predictor of a bore program that finishes on schedule.
Contractors
Municipal drilling contractors are listed here by state and city. In the Southeast the listed contractor is Davis Underground Solutions, which bores for cities, counties and utility districts across the region. Elsewhere the national line routes your project to a contractor working your area. Estimates and pre-bid site walks are free.
Services
Directional Drilling
Horizontal directional drilling (HDD) for new underground utilities: steered bores under roads, driveways, parking lots, creeks and landscaping with no open trench.
Horizontal Boring
Horizontal boring for conduit, casing and carrier pipe where digging across a surface is not an option.
Auger Boring
Steel-cased auger bores for road, rail and railroad crossings that need a straight, on-grade casing.
Pipe Boring
Boring and pulling in HDPE or steel product pipe from a few inches up to large-diameter casings.
Fiber Optic Drilling
Directional drilling for fiber and communications duct: long bores, multiple ducts in one pull, tight easements.
Electrical Conduit Drilling
Bores for primary and secondary power conduit, lighting circuits and site electrical feeds.
Utility Drilling
Multi-utility installs for developers and utilities: power, gas, water, sewer and telecom on one site plan.
Sewer Line Drilling
Directional drilling and boring for new gravity-adjusted force mains, laterals and sewer crossings.
Water Main Drilling
HDD installation of new water mains and service lines, including creek and road crossings.
Gas Line Drilling
Bores for new natural gas mains and services, coordinated with the utility and its operator-qualification rules.
Questions
Can a city replace a water main without closing the street?+
Yes. The new main is bored while the old one stays in service, services are switched over and the old main is abandoned in place. Only the tie-in and service pits are cut.
What specification governs municipal HDD?+
Most agencies reference ASTM F1962 for the pullback design and their own standards for cover, pipe, testing and restoration. Ask the contractor for the bore plan and pullback calculation on each crossing.
Is auger boring or HDD better for a gravity sewer crossing?+
Auger boring with a casing for grade-critical crossings and under highways and railroads; HDD for force mains, pressure sewer and short gravity runs with adequate slope.